Set Lu-Qos-Schedule - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set lu-qos-schedule

set lu-qos-schedule

This command sets the details of the QoS schedule.
■
Syntax
set lu-qos-schedule -schedule-number
[-event-type
{every-day |
every-week,{mon|tue|wed|thu|fri|sat|sun},{mon|tue|wed|thu|fri|sat|sun} |
specific-day,
specific-week,
{mon|tue|wed|thu|fri|sat|sun} | none} ]
[-event-from
[-event-to hhmm
■ Parameter
-schedule-number
-event-type Optional. This parameter specifies the QoS schedule event type.
MMDD R
, |
MM
,{1st|2nd|3rd|4th|last},{mon|tue|wed|thu|fri|sat|sun},
hhmm
]
]
This parameter specifies the QoS schedule number. Multiple QoS schedule numbers can only
be specified when "none" is specified for the "-event-type" parameter. From 0 to 511 can be
specified for the ETERNUS DX80 S2/DX90 S2,ETERNUS DX410 S2/DX440 S2, and ETERNUS
DX8100 S2, and from 0 to 2047 for the ETERNUS DX8700S2.
Example: -schedule-number 1,2
-schedule-number 0-10
-schedule-number 1,2-9
every-day The QoS schedule is applied to every day. A suboperand is not required.
Example: -event-type every-day
every-week The QoS schedule is applied to every week. This format is "every-week,STA,END".
The start day of the week (STA) and the end day of the week (END) are separated
by a comma. The day of the week must be specified in the following format. The
end day of the week must be after the start day of the week. The first day starts
from Monday.
Example: Correct -> -event-type every-week,mon,fri
(from Monday to Friday is OK)
Example: Incorrect -> -event-type every-week,fri,tue
(from Friday to Tuesday is not OK)
Example: Correct -> -event-type every-week,mon,mon
(only Monday is OK)
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
schedule_number
343
P2X0-1030-09ENZ0