Fujitsu ETERNUS DX80 S2 Cli User's Manual page 35

Chapter 2 Status Display
2.1 Storage System Status > show enclosure-status
Cache Mode
Remote Support
Operation Mode
CLI Connecting Controller Module
Firmware Version
Controller Enclosure
Drive Enclosure #n
System Message
The following information is output for the controller enclosure components:
Intake Temp
Exhaust Temp
CM#n
FRT#n
BRT#n
The cache control mode (Write Back Mode or Write Through Mode)
The remote support state (Operating, Maintenance, Stopping, or Not yet Set)
Stopping indicates a temporarily stopped status.
The operation mode (Maintenance mode or normal operation mode)
Controller module that has an active CLI connection.
Current firmware version
Controller enclosure status
Indicates the number of the drive enclosure and its status
Example: Drive Enclosure #1 [ status ]
(giving the status of drive enclosure)
Messages that identify the error events that have occurred in the system.
Intake temperature status, status code, and intake temperature values. Each controller has
two redundant intake temperature sensors, and both temperature values is displayed in
Celsius. If a sensor fails, "Failed" is displayed.
Exhaust temperature status and the status code.
Note that exhaust temperature values are not displayed.
Controller Module # status and the status code. The "#n" in the field indicates the controller
module number.
Example: CM#1 [Status / Status Code]
(For controller module#1)
Front End Router status and the status code (only for the ETERNUS DX8700 S2). The "#n" in the
field indicates the Front End Router number.
Example: FRT#1 [Status / Status Code]
(For Front End Router#1)
Back End Router status and the status code (only for the ETERNUS DX8700 S2). The "#n" in the
field indicates the Back End Router number.
Example: BRT#1 [Status / Status Code]
(For Back End Router#1)
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
35
P2X0-1030-09ENZ0