Create Snmp-View - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.3 Network Management > create snmp-view

create snmp-view

This command creates an SNMP Management Information Base view (MIB view). A MIB is a data base which
has a tree structure, and the MIB view defines a set of sub-trees for a MIB. MIB views are used to define access
scope. A maximum of ten MIB views can be created. ETERNUS DX Disk storage system has three default view
settings. These entries can also delete and modify as same as other entries. These default values are
described in the "show snmp-view" section.
Regarding the SNMP sub-trees name, the following rules apply for descriptions.
• Up to 251 characters can be specified.
• Names must be specified as a combination of numbers and periods (.). Example: "1.3.5"
• A combination of numbers and periods (.) must be used. At least one period (.) must be used. Example:
"15" is NG.
• The number "0" cannot be specified between period (.) characters. Example: "1.0.1" is NG.
• Numbers that begin with 0 cannot be specified. Example: "1.01.1" is NG.
■ Syntax
create snmp-view -view
subtree4
[-subtree4
subtree8
[-subtree8
[-include-subtree
■ Parameter
-view
-subtree1
. . .
-subtree10
-include-subtree
view_name [-subtree1
subtree5
] [-subtree5
subtree9
] [-subtree9
subtree_numbers
] [-exclude-subtree
This parameter specifies the MIB view name. A maximum of 10 MIB views can be specified. It is
a unique name. Up to 32 characters can be specified for a view name and at least one
character must be specified.
Optional. These parameters specify the accessible sub-trees that make up the specified MIB
view (up to 10 sub-trees). If omitted or only two double quotation marks ("") are specified, the
subtree is deleted. Each sub-tree must be unique. If duplex is specified, the command
terminates with an error.
Optional. This parameter specifies the "include" subtree type. A value between 1 and 10 can be
specified for the subtree number. Two or more subtree numbers can be specified by using "," or
"-".
If this parameter and the "-exclude-subtree" parameter are omitted, "include" is used as the
default for subtree.
The "-include-subtree" and "-exclude-subtree" parameters cannot both be specified for the
same subtree.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
subtree1 ] [-subtree2
subtree6
] [-subtree6 ] [-subtree7
subtree10
] [-subtree10 ]
subtree_numbers
476
subtree2 ] [-subtree3 subtree3
subtree7
]
]
P2X0-1030-09ENZ0
]