Create Role - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.1 User Management > create role

create role

This command creates a new user-defined role to which any policy is assigned. Multiple policies can be
assigned to one role. Role names that are already registered cannot be used to create new roles.
■ Syntax
create role -name
■ Parameter
-name
-policy
■ Example(s)
The following example creates a Total Administrator as Role 1 to which the "Status Display", "User
Management", and "Authentication Management" policies are assigned:
CLI> create role -name Role1 -policy 1,11,12
name policy
-policy
This parameter specifies a unique name for the new role. Usable characters are alphanumeric
(case-sensitive), exclamation mark (!), hyphen (-), underscore (_), and dot (.) characters. A
minimum of 1 letter and a maximum of 16 letters are required.
This parameter specifies the policies that are assigned to the role. Use the numbers that are
listed below to specify policies. Multiple policies can be specified at the same time. Enter a
comma (,) or a hyphen (-) between numbers to specify multiple policies. Note that spaces are
not permitted before or after commas (,).
1 Status Display
2 RAID Group Management
3 Volume - Create/Modify
4 Volume - Delete/Format
5 Host Interface Management
6 Advanced Copy Management
7 Copy Session Management
8 Storage Migration Management
9 Resource Domain Management (not supported)
10 Storage Management
11 User Management
12 Authentication/Role
13 Security Setting
14 Audit Setting (not supported)
15 Maintenance Information
16 Maintenance Operation
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
358
P2X0-1030-09ENZ0