Fujitsu ETERNUS DX80 S2 Cli User's Manual page 214

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-mtu
-bandwidth Optional. This parameter specifies the bandwidth limit when iSCSI-RA, which is only used for
-chap-ca
-chap-user-ca
-chap-ra
-chap-user-ra
-rec-line-no Optional. This parameter specifies the REC line number. If omitted, the existing setting is not
Optional. Specify the MTU size when RA is used. The specified value is only valid when the RA
mode or CA/RA auto mode is used. The initial value is 1300. From 576 to 9000 can be specified
when IPv6 is disabled, from 1280 to 9000 can be specified when IPv6 is enabled, and from
1000 to 1400 (increments of 50) or 1438 can be specified when iSCSI-RA, which is only used for
connecting older models, is used. If omitted, the existing setting is not changed.
connecting older models, is used. The specified value is only valid for iSCSI-RA, which is only
used for connecting older models. The initial value is 400Mbit/s. The allowed range is from 10
to 400. If omitted, the existing setting is not changed.
Optional. This parameter specifies whether or not CHAP authentication is used. If omitted, this
setting is not changed. This parameter is used for the CA setting of CA/RA dual-purpose ports.
enable A CHAP authentication is used.
disable A CHAP authentication is not used.
Optional. This parameter specifies the user name for CHAP authentication. It is only applicable
if CHAP authentication is used. If omitted, this setting is not changed. Up to 255
alphanumerical characters and symbols can be used. When this parameter is specified, a
prompt that requires entering the CHAP user pass-word appears. To delete a currently
registered CHAP user name, specify consecutive double quotations (-chap-user "") without any
spaces. This parameter is used for the CA setting of CA/RA dual-purpose ports.
Optional. This parameter specifies whether or not CHAP authentication is used. this setting is
not changed. This parameter is used for the RA setting of CA/RA dual-purpose ports.
enable A CHAP authentication is used.
disable A CHAP authentication is not used.
Optional. This parameter specifies the user name for CHAP authentication. It is only applicable
if CHAP authentication is used. If omitted, this setting is not changed. Up to 63 alphanumerical
characters and symbols can be used. When this parameter is specified, a prompt to require
entering CHAP user password. To delete a currently registered CHAP user name, specify the
consecutive double quotations (-chap-user "") without any spaces. This parameter is used for
the RA setting of CA/RA dual-purpose ports.
If this parameter is enabled, make sure the jumbo frame is supported by devices when
connected via iSCSI.
changed. This parameter can be specified only when the RA mode or CA/RA auto mode is used.
0 – 127 Specify the REC line number.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
214
P2X0-1030-09ENZ0