Set Flexible-Tier-Volume - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.4 Volume Management > set flexible-tier-volume

set flexible-tier-volume

This command modifies the information for the Flexible Tier Volumes (FTVs) that are already registered in the
ETERNUS DX Disk storage system.
■ Syntax
set flexible-tier-volume {-volume-number
[-name name
■ Parameter
-volume-number
or
-volume-name
-name
-priority
-attention
-copy-protection
■ Example(s)
The following example renames an FTV named "FTV0003" to "FTV_0003":
CLI> set flexible-tier-volume -volume-name FTV0003 -name FTV_0003
] [-priority { ftsp_number |auto}] [-attention
This parameter specifies the FTV identifier for which the settings are to be changed. Only one
parameter can be specified in a single command. For details, refer to
(page 22).
Optional. This parameter specifies the new name of the target FTV. For details, refer to
Alias Name Syntax" (page
unchanged.
Optional. This parameter specifies the FTRP number of the Flexible Tier Sub Pool (FTSP) to
which the target FTV is preferentially allocated.
If "auto" is specified for this parameter, the allocated FTSP is determined automatically. If
omitted, this parameter is not changed.
Optional. This parameter specifies the threshold (Caution) for the target FTV. A value between
1% and 200% can be set. If omitted, this parameter is not changed.
Optional. This parameter prevents the FTV from being specified as the copy destination. When
"enable" is specified, the target FTV cannot be specified as the copy destination. When
"disable" is specified, the target FTV can be specified as the copy destination. If omitted, the
setting remains unchanged.
enable The FTV is protected.
disable The FTV is not protected.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
volume_number
| -volume-name
attention ] [-copy-protection {enable | disable}]
20). If omitted, the alias name of the target FTV remains
178
volume_name
}
"1.2.9 Volume Syntax"
"1.2.4
P2X0-1030-09ENZ0