Fujitsu ETERNUS DX80 S2 Cli User's Manual page 438

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > set rec-buffer
-remote-boxid
-buffer-size Optional. This parameter specifies the REC buffer size. This parameter must be specified for the
-buffer-type
-forwarding-interval
Optional. This parameter specifies the Box ID of a single remote storage system that is to be
defined. Only one Box ID can be specified at a time. Only one Send/Receive REC buffer transfer
can be set using the Box ID of a single remote storage system. This parameter must be
specified for the initial setup. If omitted, this parameter value is not changed.
• Box IDs use a maximum of 40 alphanumeric characters, spaces, and pound key characters
(#).
• All alphabetic characters are handled as uppercase.
• The pound key characters (#) are automatically appended when the input characters are
less than 40.
initial setup. If omitted, this parameter value is not changed. The size of each REC buffer can be
selected as follows:
ETERNUS DX90 S2:128MB, 256MB, and 512MB
ETERNUS DX410 S2/DX440 S2:128MB, 256MB, 512MB, 1024MB, and 2048MB
ETERNUS DX8100 S2/DX8700 S2:128MB, 256MB, 512MB, 1024MB, 2048MB
Optional. This parameter specifies the REC buffer type. This parameter must be specified for
the initial setup. If omitted, this parameter value cannot be changed.
receive Use as a Receive buffer.
send Use as a Send buffer.
Optional. This parameter specifies the interval at which data should be transferred. A long
interval will reduce the Host I/O overhead, but increase the amount of data susceptible to loss
in the event of disaster. This parameter must be specified for the initial setup. If omitted, this
parameter value is not changed.
1 1 second (Recommended value)
2 2 seconds
4 4 seconds
8 8 seconds
15 15 seconds
30 30 seconds
45 45 seconds
60 60 seconds
75 75 seconds
90 90 seconds
105 105 seconds
120 120 seconds
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
438
P2X0-1030-09ENZ0