Set Host-Sas-Address - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-sas-address

set host-sas-address

This command changes the details of an existing SAS host.
■
Syntax
set host-sas-address {-host-number
address
[-address
-host-response-name
■ Parameter
-host-number
or
-host-name
-address
-name
-host-response-number
or
-host-response-name
■ Example(s)
The following example changes the host named "HBA1", assigning it host response number "2":
CLI> set host-sas-address -host-name HBA1 -host-response-number 2
The following example changes the host response definition of all the hosts with consecutively numbered
identifiers #1 to #10 at the same time:
CLI> set host-sas-address -host-number 1-10 -host-response-number 5
host_number
name
] [-name ] [-host-response-number
host_response_name
This parameter specifies the identifier of the SAS host whose details are to be changed. If only
the host response identifier is being set, then one or more SAS host identifiers can be specified
at the same time. If not, then only one SAS host identifier can be specified. For details, refer to
"1.2.10 Host Syntax" (page
Optional. This parameter specifies the SAS address, which is a 16 character hexadecimal
number that corresponds to a HBA. Only one SAS address can be specified at any given time. If
omitted, the existing setting is not changed.
Example: -address 500605b000b5f344
Optional. This parameter specifies the new SAS address alias. Only one name can be specified
at the same time. For details, refer to
existing setting is not changed.
Optional. This parameter specifies a host response identifier. One or more parameters can be
specified at the same time. For details, refer to
omitted, the existing setting is not changed.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
host_name
| -host-name
host_response_number
]
23).
"1.2.4 Alias Name Syntax" (page
"1.2.12 Host Response Syntax" (page
235
}
|
20). If omitted, the
24). If
P2X0-1030-09ENZ0