Fujitsu ETERNUS DX80 S2 Cli User's Manual page 508

Chapter 4 Function/System Settings and Display
4.3 Network Management > set email-notification
-retry-count Optional. This parameter specifies the number of retries that are performed when an e-mail
-retry-interval
-timeout
• The number after "-text" indicates the message line number. For example, "-text5" indicates
the 5th line. With the exception of the last line, two bytes of carriage return code (CR) are
added to each non-blank line.
Example: -text1 Hello -text2 Hello -text3 Hello
The total number of characters is 19 (5*3 + 2*2)
• The messages must be specified in ascending order beginning at "-text1".
Example: -text1 Hello
-text2 Morning.
-text3 bye.
- A pair of consecutive double quotation marks indicates a blank line.
Example: -text1 Hello
-text2 ""
-text3 bye
Result of this example:
line1 : Hello
line2 :
line3 : bye
* Line2 is blank.
- If a line includes a blank letter, both ends of the parameter must be enclosed by double
quotation marks ("). Double quotation marks are not include in the word count.
Example: -text1 Hello.
-text2 "This is your system." (20 letters)
- To include a double quotation mark, precede it by the back slash character. Back slash
characters are not include in the word count.
Example: -text1 abc\"def \"ghi (11 letters)
Result of this example:
abc"def"ghi
fails to send. Specify 0 or 1 for the retry count. If omitted, the existing setting is not changed.
The default value is 0 (no retry).
0 No retry (default).
1 Retry once.
Optional. This parameter specifies the time of the interval to retry sending. Between 1 and 5
seconds should be specified for the value. If omitted, the existing setting is not changed. The
default value is 1 (a retry is attempted after a 1 second interval).
Optional. This parameter is only available for the ETERNUS DX Disk storage system that does
not have the REMCS support function. If this parameter is specified for an ETERNUS DX Disk
storage system that has the REMCS support function, this command terminates. This
parameter specifies the time out value to connect to the SMTP server in seconds. Between 1
and 30 can be specified (1 to 30 seconds). If omitted, the existing setting is not changed.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
508
P2X0-1030-09ENZ0