Fujitsu ETERNUS DX80 S2 Cli User's Manual page 690

Appendix A Error Messages
Message
number
E0053
E0060
E0061
E0070
E0071
E0072
E0080
E0081
E0089
E0090
E0091
E0092
Remote server access failure.
This message indicates that the email notification cannot access the SMTP server. Use the "show network"
command to check the remote server environment and the network environment. Use the "show email-
notification" command to check the email notification settings.
Resource locked.
The resource is being used by another session. Wait for a while and retry the command. If this error
message continues to recur even after numerous command retries, a resource can be forcibly released by
using the "set clienv-force-unlock" command (do not use this command while settings are being
performed by another session of Web GUI, CLI, or monitoring software).
Lock was relinquished to another user.
The process privilege is taken by another user (GUI, CLI, or monitoring software). Wait for a while and try
again.
Resource busy.
Resources corresponding to the specified parameter are used by another process. Check the working
status of the resources identified in the details of this message.
Resource is linked to the other resource.
The specified parameter is associated with other resources. Confirm the associated status of the specified
parameter (Example: host mappings, ECO definitions, etc.).
Release the association if necessary and try again. For example, host mappings can be released by using
the "release host-affinity" command and/or the "release mapping" command, and Eco-mode definitions
can be deleted by using the "release eco-raid-group" command.
Resource is temporarily insufficient.
Could not execute because the required resource is temporarily insufficient. Wait for a while and retry the
command.
Resource limited.
A resource has reached its limit. Confirm the limit and the status of the specified parameter/function.
Number of active disks has reached the system limit.
Number of activated disks has reached the system limit (up to 120 disks can be used). Mixed
configurations that include both 3.5" and 2.5" type disks are allowed.
Not available under current Advanced Copy usable mode conditions.
The current Advanced Copy mode does not permit this operation. Use the "show advanced-copy-
parameters" command to check the Advanced Copy usable mode.
The Advanced Copy usable mode can be canceled by using the "set advanced-copy-parameters"
command if necessary.
Not available under current system status conditions.
The current system status does not permit this operation. Check the system status and the allowed
execution conditions for the operation.
Not available under current SNMP settings.
The current SNMP mode does not permit this operation. Check the SNMP mode by using the "show snmp"
command.
The SNMP mode can be changed by using the "set snmp" command if necessary.
Not available under current operation mode conditions.
The current operation mode does not permit this operation. Check the operation mode by using the
"show enclosure-status" command.
The operation mode can be set by using the "start maintenance" command or canceled by using the "stop
maintenance" command if necessary.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Message
Countermeasure for the error
690
P2X0-1030-09ENZ0