Fujitsu ETERNUS DX80 S2 Cli User's Manual page 355

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos-performance
The following example displays the performance measurement information when a host interface port with
the host affinity mode enabled and a host (the port type is iSCSI and the host IP address is not set) are set:
CLI> show host-lu-qos-performance -port 000 -host-number 0
CM#0 CA#0 Port#0 Port Performance Information
Port Type
Host Affinity
Performance Monitoring ON
Monitoring Start Time
Monitoring Stop Time
Host Performance Information
Host No.
Host Name
iSCSI Name
IP Address
Host Total
LUN
1
1021
Host Performance Information
Host No.
Host Name
iSCSI Name
IP Address
Host Total
LUN
1
1021
The following example displays the performance measurement information when performance
measurements are not performed and a host interface port is set:
CLI> show host-lu-qos-performance -port 000
CM#0 CA#0 Port#0 Port Performance Information
Port Type
Host Affinity
Performance Monitoring OFF
ISCSI
Enable
2012-04-11 12:00:00
2012-04-11 12:05:00
0
HOST#0
iqn.1991-05.com.microsoft
192.168.43.151
IOPS
Ave Min Max
111000 110 222000
IOPS
Ave Min Max
20 10 100
60 11 30
0
HOST#0
iqn.1991-05.com.microsoft
192.168.43.152
IOPS
Ave Min Max
111000 110 222000
IOPS
Ave Min Max
20 10 100
60 11 30
ISCSI
Enable
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Throughput(MB/s)
Ave Min Max
20 10 30
Throughput(MB/s)
Ave Min Max
2 1 3
2 1 2
Throughput(MB/s)
Ave Min Max
20 10 30
Throughput(MB/s)
Ave Min Max
2 1 3
2 1 2
355
Delay Time(ms)
Total Ave
1000 10
Delay Time(ms)
Total Ave
20 10
120 10
Delay Time(ms)
Total Ave
1000 10
Delay Time(ms)
Total Ave
20 10
120 10
P2X0-1030-09ENZ0