Create Lun-Group - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > create lun-group

create lun-group

This command creates a LUN group. The maximum number of available groups depends on the number of
available host interface ports and the model type. Usually a LUN can be assigned a value from 0 – 255. Note
that this does not apply in the following environments:
• HP-UX host environment
From 0 – 1023 can be assigned. The resource combines two LUN groups.
• BS2000 environment
From 0 – 4095 can be assigned. The resource combines eight LUN groups.
■ Syntax
create lun-group -name
{-volume-number
■ Parameter
-name
-volume-number
or
-volume-name
-lun
■ Example(s)
The following example creates the LUN group named "AG001". It will associate volume #8 with LUN #10:
CLI> create lun-group -name AG001 -volume-number 8 -lun 10
name
volume_numbers
| -volume-name
This parameter specifies a name of the LUN group. Only one name can be specified at the
same time. For details, refer to
This parameter specifies the volume identifiers to associate volumes with host LUNs. One or
more parameters can be specified at the same time. For details, refer to
(page 22). If two or more LUNs are specified, these parameters must be specified in the same
order.
Example:
-volume-number 10-12 -lun 1-3
-> The volume #10 and LUN 1 are pairs.
-> The volume #11 and LUN 2 are pairs.
-> The volume #12 and LUN 3 are pairs.
-volume-name v1,v2 -lun 1-2
-> The volume named "v1" and LUN 1 are pairs.
-> The volume named "v2" and LUN 2 are pairs.
This parameter specifies the host LUNs to associate volumes with. Two or more parameters can
be specified by separating them with a comma, a hyphen, or both. If two or more volumes are
specified, these parameters must be specified in the same order.
Example: -lun 0,1 -lun 0-10 -lun 0,1-10
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
volume_names
} -lun
"1.2.4 Alias Name Syntax" (page
261
luns
20).
"1.2.9 Volume Syntax"
P2X0-1030-09ENZ0