Chapter 5 Information Settings and Display
5.4 Utility > show event-parameters
show event-parameters
This command displays the parameters set by the "set event-parameters" command.
■
Syntax
show event-parameters
■
Parameter
No parameters.
■
Output
# Blink Panel Fault LED
A
# Redundant Copy Fault LED [Enable ]
B
A:
It shows whether the Panel Fault LED is blinked or not when the system status is warning.
B:
It shows whether the Fault LED lights up or not when the redundant copy is complete.
■
Example(s)
The following example displays the event parameters:
CLI> show event-parameters
Blink Panel Fault LED
Redundant Copy Fault LED [Enable ]
[Enable ]
[Enable ]
670
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0