Fujitsu ETERNUS DX80 S2 Cli User's Manual page 295

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-response
-iscsi-disc-rsp
-tpgs
-tpg-referrals
-iscsi-rsv-range
■
Example(s)
The following example sets up the host response for host response #1. The new host response name is "win-
x". The response status is Busy status. The host command timeout is 30 seconds:
CLI> set host-response -host-response-number 1 -name win-x -status busy -timeout 30
Optional. This parameter specifies the reply mode for the iSCSI Discovery request.
port Replies to the server with only the information for the specified iSCSI ports (iSCSI
names and IP addresses).
all Replies to the server with the information for all the iSCSI ports (iSCSI names and
IP addresses).
Optional. This parameter specifies whether to enable Target Port Group Support (TPGS) for
Inquiry Standard Data Version 5.
enable TPGS is enabled (default).
disable TPGS is disabled.
Optional. This parameter specifies whether to enable the TPG Referrals. When "enable" is set
for this parameter, TPG Referrals are only performed when TPGS is enabled and Asymmetric/
Symmetric Logical Unit Access is set to ACTIVE/ACTIVE-PRFERRED_PATH.
Set "enable" for this parameter only for connection environments in which the ETERNUS Mul-
tipath Driver that is being used supports TPG Referrals.
enable TPG Referrals is enabled.
disable TPG Referrals is disabled (default).
Optional. This parameter specifies the reservation management range for iSCSI connections.
port Each CA port
system Each storage system
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
295
P2X0-1030-09ENZ0