Specifying A Port Group And Performing Lun Mapping - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Appendix D Basic Setting Examples
D.2 Settings for Various Host Accesses
D.2.2

Specifying a Port Group and Performing LUN Mapping

An example of setting up host access is shown below. For more details, refer to
Management" (page
The example shown below is the case for the Fibre Channel interface.
Procedure
1
Set the connection of host interface ports 000 and 100 to fabric.
The following example shows the case for the Fibre Channel interface.
CLI> set fc-parameters -port 000,100 -connect fabric
2
Group host interface ports 000 and 100 together, and create a port group named PG0001.
CLI> create port-group -name PG0001 -port 000,100
3
Map a volume with a LUN, and create an affinity group named AG002.
CLI> create affinity-group -name AG002 -volume-name v2 -lun 20
In this example, volume v2 and LUN 20 are mapped.
4
Set the relationship between port group PG0001, affinity group AG002, and host response
number 0.
CLI> set host-affinity -port-group-name PG0001 -ag-name AG002 -host-response-number
When Step 4
commands vary.
• set lun-group, delete lun-group
• set affinity-group, delete affinity-group
The "set lun-group" and "delete lun-group" commands change the LUN mapping that is set by specifying a
port group in response to the changed setting of the LUN group.
Example
CLI> set lun-group -lg-name AG002 -volume-name v0 -lun 0
CLI> show mapping
CM#0 CA#0 Port#0 (Host Affinity Mode Disable)
LUN Volume
No.
0 8 v0
20 10 v2
CM#0 CA#0 Port#1 (Host Affinity Mode Disable)
CM#1 CA#0 Port#0 (Host Affinity Mode Disable)
LUN Volume
No.
0 8 v0
20 10 v2
CM#1 CA#0 Port#1 (Host Affinity Mode Enable)
193).
is performed for mapping (specifying the port group), the results of executing the following
Status
Name
Available
Available
Status
Name
Available
Available
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Size(MB)
Size(MB)
744
"3.5 Host Interface
End of procedure
512
512
512
512
P2X0-1030-09ENZ0
0