Fujitsu ETERNUS DX80 S2 Cli User's Manual page 44

Chapter 2 Status Display
2.1 Storage System Status > show fru-ce
SCU
SCU Voltage
CM MMC
CM MMC Active EC
CM MMC Next EC
CM MMC Firmware Version
PCH
CM#n CA#m Port#l Information (n: The controller module number, m: The Channel Adapter number, l:
The port number)
(For FC, iSCSI, FCoE, and SAS)
Port Type
Port Mode
Status/Status Code
CA Active EC
CA Next EC
Connection Connection condition
Loop ID
Transfer Rate
Link Status
Port WWN
SCU (System Capacitor Unit) status and the status code (ETERNUS DX80 S2/DX90 S2 only)
SCU: This word stands for System Capacitor Unit: SCUs are electric double layer capacitors
embedded in a controller module that provides the power to move the cache data to the NAND
flash memory if there is a power outage.
Charging voltage of SCU (only for the ETERNUS DX80 S2/DX90 S2)
CM MMC status and the status code (ETERNUS DX8700 S2 only)
An EC number of the active firmware (The current operating firmware) (ETERNUS DX8700 S2
only)
An EC number of the stand-by firmware (The generation number of the firmware after the next
power cycle) (ETERNUS DX8700 S2 only)
CM MMC firmware version (ETERNUS DX8700 S2 only)
PCH status and the status code
It shows if the host interface port type is FC, iSCSI, FCoE, or SAS.
It shows if the host interface port mode is CA, RA, CA/RA auto, or Initiator.
Host interface Port (Port#m) status and the status code
An EC number of the active firmware (The current operating firmware)
An EC number of the stand-by firmware (The generation number of the firmware after the next
power cycle)
Loop ID
Transfer rate (A value specified by the operator)
Link status (Link Up, Link Down, or if requesting auto negotiation, then the actual transfer rate
is displayed.)
Port World-Wide-Name
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
44
P2X0-1030-09ENZ0