Fujitsu ETERNUS DX80 S2 Cli User's Manual page 692

Appendix A Error Messages
Message
number
E0116
E0117
E0118
E0120
E0122
E0123
E0131
E0132
E0140
E0141
E0142
E0143
E0144
E0145
E0146
The system disks are included in the RAID group.
System disks exist in the RAID group.
No target disks.
The target disks do not exist. Confirm the disk status or details by using the "show disks" command.
Remote Copy target is not supported model.
The specified storage system is not supported for Remote Equivalent Copy. Check whether or not to specify
an appropriate storage system.
Already registered.
The resource is already registered. Check the status of the object shown in the details of this message.
Closure of all CLI and GUI ports requires confirmation.
Displayed when all the connections methods for both the CLI and GUI are to be disabled. If this is
intentional, retry the command with the "-confirm-close-all yes" parameter specified to make the storage
system inaccessible via CLI or GUI.
Closure of all CLI ports requires confirmation.
Displayed when all the CLI connection methods are to be disabled. If this is intentional, retry the
command with the "-confirm-close-all yes" parameter specified to make the storage system inaccessible
via CLI.
Already unmapped.
Resources corresponding to the specified parameter are already unmapped. Check the resources
identified in the details of this message.
Already stopped.
Resources corresponding to the specified parameter are already stopped. Check the resources identified in
the details of this message.
One or more components have failed.
One or more components have failed during the maintenance operation. Check the reason for the failure
or take log files and ask the support department to investigate.
At least one resource is required.
At least one or more resources are required. Check the specification.
One or more encrypted volumes exist.
Cannot execute this command because encrypted volumes exist. Please check the status of volumes by
using the "show volumes" command.
Unexpected error occurred during operator intervention.
During operator intervention, an unexpected error occurred (Example: the terminal session was suddenly
disconnected). Try the operation again.
Expanding drive enclosure condition.
A drive enclosure is currently being added. Wait for expansion to complete and try again.
Advanced Copy table exists.
Advanced Copy table has already been defined in the system. Check the Advanced Copy table size by
using the "show advanced-copy-parameters" command. The table size should be zero.
Set the Advanced Copy table size to 0 by using the "set advanced-copy-parameters" command if neces-
sary.
RAID group contains a temporary volume.
Could not execute because a temporary volume exists in the RAID group. If necessary, retry the command
after deleting the temporary volume.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Message
Countermeasure for the error
692
P2X0-1030-09ENZ0