Fujitsu ETERNUS DX80 S2 Cli User's Manual page 215

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-rec-transfer-sync
-rec-transfer-stack
-rec-transfer-consistency
-rec-transfer-through
■ Example(s)
The following example disables Host Affinity Mode for iSCSI interface port#0 on CM#1 CA#0:
CLI> set iscsi-parameters -port 100 -host-affinity disable
The following example sets "192.168.1.1" for the IP address, "255.255.255.0" for the subnet mask, and
"user01" for the CHAP user name of iSCSI interface port#1 on CM#0 CA#1:
CLI> set iscsi-parameters -port 001 -ip 192.168.1.1 -netmask 255.255.255.0 -chap-user user01
Password :
Confirm Password :
The following example enables the jumbo frame function on all iSCSI interface ports:
CLI> set iscsi-parameters -port all -jumbo-frame enable
Optional. This parameter specifies the synchronous mode for the copy transfer mode. If
omitted, the existing setting is not changed. This parameter can be specified only when the RA
mode or CA/RA auto mode is used.
enable An REC in synchronous transfer mode is permitted for the target CA port.
disable An REC in synchronous transfer mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous stack mode for the copy transfer mode. If
omitted, the existing setting is not changed. This parameter can be specified only when the RA
mode or CA/RA auto mode is used.
enable An REC in asynchronous stack mode is permitted for the target CA port.
disable An REC in asynchronous stack mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous consistency mode for the copy transfer
mode. If omitted, the existing setting is not changed. This parameter can be specified only
when the RA mode or CA/RA auto mode is used.
enable An REC in asynchronous consistency mode is permitted for the target CA port.
disable An REC in asynchronous consistency mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous through mode for the copy transfer mode.
If omitted, the existing setting is not changed. This parameter can be specified only when the
RA mode or CA/RA auto mode is used.
enable An REC in asynchronous through mode is permitted for the target CA port.
disable An REC in asynchronous through mode is suppressed for the target CA port.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
215
P2X0-1030-09ENZ0