Fujitsu ETERNUS DX80 S2 Cli User's Manual page 213

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-rate
-cmdsn-count
-vlan-id
-vlan-id-value
Optional. This parameter specifies the connection speed of the iSCSI port. If omitted, the
existing setting is not changed. The default value is 1Gbit/s for 1Gbit/s iSCSI and iSCSI-RA (for
connecting older models) and 10Gbit/s for 10Gbit/s iSCSI.
For 1Gbit/s iSCSI
1gauto 1Gbit/s / Auto
For 1Gbit/s iSCSI CA/RA auto mode
For 10Gbit/s iSCSI
10gauto 10Gb/s / Auto
For 10Gbit/s iSCSI CA/RA auto mode
For iSCSI-RA (for connecting older models)
auto Auto negotiation.
1gfull 1Gbit/s / Full Duplex
100mfull 100Mbit/s / Full Duplex
Optional. For Advanced authority users, this parameter specifies the number of commands
that are simultaneously acceptable from a host. The initial value is set to unlimited. This
parameter cannot be specified when the port is set to the RA mode. Use this parameter only
when instructed by our service engineer. Standard and Monitor authority users cannot be
used.
unlimited The number of commands is not limited.
20 Limited to a maximum of 20 commands.
40 Limited to a maximum of 40 commands.
80 Limited to a maximum of 80 commands.
120 Limited to a maximum of 120 commands.
180 Limited to a maximum of 180 commands.
Optional. This parameter specifies VLAN connection enable or disabled. When "enable" sets,
must be set the "-vlan-id-value" parameter. To set "enable", the "-vlan-id-value" parameter
must be set.
enable VLAN connection enabled.
disable VLAN connection disabled.
Optional. This parameter specifies the VLAN ID value for connect to VLAN. When "-vlan-id
enable" is done, this parameter must be set. "-vlan-id" must be set to "enable" for this
parameter.
0 – 4095 VLAN ID value
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
213
P2X0-1030-09ENZ0