Set Host-Lu-Qos - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-lu-qos

set host-lu-qos

This command performs detailed settings for the Host-LU QoS function. This command can change the QoS
settings for Port QoS, Host QoS, and LU QoS.
■ Syntax
set host-lu-qos -mode {port-qos|host-qos|lu-qos}
{-port { xyz |all} [-bandwidth-limit
[-schedule-number
{-host-type {fc|iscsi|sas} {-host-number
[-bandwidth-limit
[-schedule-number
xyz
{-port [{-host-number
[-lu-qos-group
[-schedule-number
■ Parameter
-mode
-port
bandwidth-limits
schedule-numbers
]}
host_numbers
bandwidth-limits
] [-event-number
schedule-numbers
]}
host_numbers
lu_qos_group_numbers ] [-event-number
schedule_numbers
]}
This parameter specifies which QoS settings are changed.
port-qos Port QoS
host-qos Host QoS
lu-qos LU QoS
This parameter specifies the host interface port when Port QoS or LU QoS is set.
Example: -port 00
For details, refer to "1.2.14 Host Interface Port Syntax" (page
• When "lu-qos" is specified for the "-mode" parameter, "all" cannot be specified.
• When "lu-qos" is specified for the "-mode" parameter, the type (FC, iSCSI, SAS) of all the
ports that are specified by the "-host-number" or "-host-name" parameter must be the
same.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
] [-event-number
| -host-name
event-numbers
host_names
| -host-name }]
event_numbers
334
event-numbers ]
host_names
}
]
]
25).
P2X0-1030-09ENZ0