Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show fc-parameters
■
Output
# Port
Each host interface port number
# Port Mode
It shows if either CA or RA mode is set. The RA mode is used for Remote Equivalent Copy.
# Connection
Connection condition of each FC port (loop connection (FC-AL) or fabric connection)
# Loop ID Assign
How to assign the loop ID (Loop ID is shown only when selecting manual.)
(Either ascending order or descending order is shown when selecting automatic.)
# Transfer Rate
FC transfer rate (Auto Negotiation / 1Gbit/s / 2Gbit/s / 4Gbit/s / 8Gbit/s / 16Gbit/s)
# Frame Size
FC frame size (512bytes/1024bytes/2048bytes)
# Host Affinity
Host affinity mode of each host interface port
# Host Response No.
# Host Response Name
Host response number (The hyphen is shown when the host affinity mode is enabled.)
# Reset Scope
Range of reset action I_T_L (I: Initiator, T: Target, L: LUN) or T_L (T: Target, L: LUN)
# Reserve Cancel at Chip Reset
It shows whether reservations are canceled or not when a host interface port is reset.
# REC Line No.
REC line number (0 – 127)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Sync
Synchronous mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Stack
Asynchronous stack mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Consistency -
Asynchronous consistency mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Through
Asynchronous through mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
CM#0 CA#0 Port#0
CM#0 CA#0 Port#1
CA
CA
FC-AL
FC-AL
Manual(0x01)
Auto(Ascending)
Auto Negotiation
4Gbit/s
2048bytes
512bytes
Disable
Enable
5
-
HP05
-
I_T_L
I_T_L
Disable
Enable
-
-
-
-
-
-
-
-
-
201
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
CM#0 CA#0 Port#2
CM#0 CA#0 Port#3
RA
Initiator
Fabric
Fabric
Auto(Descending)
Manual(0x01)
4Gbit/s
4Gbit/s
-
-
-
-
-
-
-
-
-
-
-
127
-
Enable
-
Disable
-
Enable
-
Disable
-
P2X0-1030-09ENZ0