Fujitsu ETERNUS DX80 S2 Cli User's Manual page 218

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show iscsi-parameters
■ Output
# CM#0 CA#0 Port#0
# Port Mode
# Host Affinity
# iSCSI Name
# Alias Name
# Host Response No.
# Host Response Name
# Reset Scope

I_T_L (I: Initiator, T: Target, L: LUN) or T_L (T: Target, L: LUN)
# Reserve Cancel at Chip Reset
# IPv4
# IP Address
# Subnet Mask
# Gateway Address
# IPv6
# Link Local IP Address
# Connect IP Address
# IPv6 Gateway Address
# MAC Address
# TCP Port Number
# TCP Window Size
# TCP Congestion Control Option Disable
# iSNS Server
# iSNS Server IP Address
# iSNS Server Port Number
# CHAP
# CHAP User Name
# Header Digest
# Data Digest
# Jumbo Frame
 The above information shows whether or not the iSCSI jumbo frame is supported.
In this case, the jumbo frame is not accepted.
# Transfer Rate
 The above information shows the transfer speed (Auto Negotiation / 100Mbit/s / 1Gbit/s / 10Gbit/s).
# Link Status
 The above information shows the actual transfer speed and "Link Up" or "Link Down" is displayed for the link status.
# CmdSN Count
# VLAN ID
# MTU
# Limit Band width
# REC Line No.
 REC line number (0 – 127)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Sync
 Synchronous mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Stack
 Asynchronous stack mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Consistency -
 Asynchronous consistency mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
# REC Transfer Mode Through
 Asynchronous through mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA auto mode.)
CA
Disable
iqn.2000-09.com.fujitsu:storage-system.eternus_dxl:000000
1
HP1
I_T_L
Disable
Enable
192.168.2.64
255.255.255.0
0.0.0.0
Enable
FE80::290:CCFF:FEA4:3A49
2001:DB8::8:800:200C:417A
FE80::2AA:FF:FE9A:21B8
01:02:03:04:05:06
3260
0
Disable
-
3205
Disable
user00
CRC32
OFF
Disable
1Gbit/s
1Gbit/s Link Up
Unlimited
Enable
4090
-
-
-
-
-
-
218
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0