Fujitsu ETERNUS DX80 S2 Cli User's Manual page 47

Chapter 2 Status Display
2.1 Storage System Status > show fru-ce
Hard Revision
BRT#n Internal Parts Status and Status Code (n: The back end router number)
(ETERNUS DX8700 S2 only)
EXP#
EXP# Active EC
EXP# Next EC
EXP# Firmware Version
InPort#
QSFP Cable#(OUT)
SVC#n Information (n: The service controller number) (ETERNUS DX8700 S2 only)
Parts Number
Serial Number
Hard Revision
MAC Address(MNT)
MAC Address(RMT)
MAC Address(FST)
LAN Control
Active EC
Next EC
Firmware Version
BRT Hard Revision
BRT Expander status and the status code
An EC number of the active firmware (The current operating firmware)
An EC number of the stand-by firmware (The generation number of the firmware after the next
power cycle)
BRT Expander firmware version
BRT Expander InPort status
BRT QSFP Cable status and the status code
SVC Parts Number
SVC Serial Number
SVC Hard Revision
SVC MAC address (MNT)
SVC MAC address (RMT)
SVC MAC address (FST)
SVC LAN Control (Master or Slave)
An EC number of the active firmware (The current operating firmware)
An EC number of the stand-by firmware (The generation number of the firmware after the next
power cycle)
SVC firmware version
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
47
P2X0-1030-09ENZ0