Show Reservation - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 5 Information Settings and Display
5.4 Utility > show reservation

show reservation

This command displays the reservation status of the volumes.
■
Syntax
show reservation [-volume-number
■ Parameter
-volume-number
or
-volume-name
■ Output
When a volume identifier is omitted:
# Volume
# No. Name
# 1 LogicalVolume1
A B
A: Volume number
B: Volume name
C: Logical unit number associated with volume
D: When Host Affinity Mode is disabled, the host interface port number assigning to the host mapping is
displayed.
E: When Host Affinity Mode is enabled, an affinity group number belonging to the volume is displayed.
F: When Host Affinity Mode is enabled, an affinity group name belonging to the volume is displayed.
Either D or E/F is displayed.
G: The number registered by a reservation Key
H: The kind of persistent reservation
I: The status of persistent Reservation
J: It shows whether it keeps reservation information or not at the occurred power cycle.
When a volume identifier is specified:
# Volume
# No. Name
# 1 Volume#1
A B
A: Volume number
B: Volume name
C: Host number
D: Host name
E: Reservation key (Identifier information used for Persistent Reservation)
F: Reservation status of a volume by a reservation key
volume_numbers
This parameter specifies the volume identifiers to be released. One or more volumes can be
specified at the same time. For details, refer to
LUN Port
11 CM#0 Port#0
C D
Host
No. Name
0 Host-name-0000
C D
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
| -volume-name
"1.2.9 Volume Syntax" (page
Affinity Group Registrant Reservation Persistent APTPL
No. Name Count
-
E F G
Reservation Hold
Key Reservation
0123456789abcdef Yes
E F
677
volume_names
]
22).
Type
32 WE Yes
H I
P2X0-1030-09ENZ0
Yes
J