Fujitsu ETERNUS DX80 S2 Cli User's Manual page 350
Disk storage systems
Hide thumbs
Also See for ETERNUS DX80 S2:
- User manual (186 pages) ,
- User's manual & installation instructions (147 pages) ,
- Overview (97 pages)
Table of Contents
Advertisement
Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos-performance
When the port number is specified (the host affinity mode is enabled):
# CM#0 CA#0 Port#0 Port Performance Information
A
# Port Type
# Host Affinity
# Performance Monitoring ON
# Monitoring Start Time
# Monitoring Stop Time
#
#
# Port Total
# Host
# No. Name
#
0 Host#FC_0
#
1 Host#FC_1
O
P
A:
Host interface port number
B:
Port type
C:
Host affinity (Enable: enabled, Disable: disabled)
D:
Measurement status (ON: performance is being measured, OFF: performance measuring is stopped)
E:
Performance measurement start time
F:
Performance measurement stop time
G:
Average number of I/Os per second for a port
H:
Minimum number of I/Os per second for a port
I:
Maximum number of I/Os per second for a port
J:
Average transfer amount per second for a port (in MB/s)
K:
Minimum transfer amount per second for a port (in MB/s)
L:
Maximum transfer amount per second for a port (in MB/s)
M:
Accumulated delay time for the start of a command due to the QoS control of a port (in milliseconds)
"Overflow" is displayed when a long time passes from the start of performance measurement to the end of
performance measurement and the accumulated delay time exceeds the limit.
N:
Average delay time for a single command due to the QoS control of a port (in milliseconds)
O:
Host number
P:
Host name
Q:
Average number of I/Os per second for a host
R:
Minimum number of I/Os per second for a host
S:
Maximum number of I/Os per second for a host
T:
Average transfer amount per second for a host (in MB/s)
U:
Minimum transfer amount per second for a host (in MB/s)
V:
Maximum transfer amount per second for a host (in MB/s)
W:
Accumulated delay time since the start of a command from the QoS control of a host (in milliseconds)
"Overflow" is displayed when a long time passes from the start of performance measurement to the end of
performance measurement and the accumulated delay time exceeds the limit.
X:
Average delay time for a single command from the QoS control of a host (in milliseconds)
FC
B
Enable
C
D
2012-04-11 12:00:00
E
2012-04-11 12:05:00
F
IOPS
Ave
Min
Max
100
1
100
G
H
I
IOPS
Ave
Min
Max
100
10
100
10
1
30
Q
R
S
350
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Throughput(MB/s)
Ave
Min
Max
2
1
100
J
K
L
Throughput(MB/s)
Ave
Min
Max
2
1
3
10
2
100
T
U
V
Delay Time(ms)
Total
Ave
1000
10
M
N
Delay Time(ms)
Total
Ave
20
10
120
10
W
X
P2X0-1030-09ENZ0
- Quick Links:
- Accessing Cli
Hide quick links:
Advertisement
Table of Contents
