I 2 C Bus Interface Pins - Fujitsu F2MC-8FX Hardware Manual

2
22.4 I C Bus Interface Pins
This section describes the pins of the I
Pins Related to I
The pins related to the I
SDA0 pin
The SDA0 pin can serve as a general-purpose I/O port, external interrupt input (hysteresis input), serial
data output pin (N-ch open-drain) for 8-bit serial I/O, and I
SDA0:When I
To use it as an input pin, enable the I
bit 4 port direction register (DDR).
SCL0 pin
The SCL0 pin can serve as a N-ch open-drain I/O port, external interrupt input (hysteresis input), serial data
input (hysteresis input) for eight-bit serial I/O, or I
SCL0:When I
function as the SCL0 terminal.
To use it as an input pin, enable the I
bit 4 port direction register (DDR).
2
C Bus Interface
2
C bus interface are the SDA0 and SCL0 pins.
2
C is enabled (ICCR0:EN = 1), the SDA0 pin is automatically set as a data I/O pin to
function as the SDA0 terminal.
2
C is enabled (ICCR0:EN = 1), the SCL0 pin is automatically set as the shift clock I/O pin to
2
C bus interface and gives their block diagram.
2
C data I/O pin (SDA0).
2
C operation (ICCR0: EN = 1) and write "0" to the corresponding of
2
C serial clock I/O pin (SCL0).
2
C operation (ICCR0: EN = 1) and write "0" to the corresponding of
2
CHAPTER 22 I C
375