NEC Electra Elite 48/192 Features And Specifications Manual page 154

Electra Elite
Features and Specifications Manual
Use Memory Blocks 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
¥
Assignment] to set Call Forward - Busy and Call Forward - No
Answer, independently, to two separate stations using separate
Access Codes.
Use Memory Block 1-2-22 (Call Forward No Answer Time Selection)
¥
to specify the time (default: 8 seconds) allowed before calls are
forwarded for Call Forward - Busy/No Answer.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
¥
Selection 1] Page 2 LK3 to Allow (LED On) or Deny (default: LED Off)
system-wide cancel of Call Forward - All Call, Busy/No Answer, and
Do Not Disturb from an Attendant Position.
Use Memory Block 1-8-08 [Class of Service (Station) Feature
¥
Selection 2] Page 2 LK5 to Allow (default: LED On) or Deny (LED Off)
setting Call Forward - Busy/No Answer.
Restrictions:
Only one Call Forward - Busy/No Answer forwarding destination can
¥
be set from one station at a time.
Call Forward - Busy/No Answer forwards to another station only
¥
once (cannot chain call).
Secondary Incoming
¥
Forward - Busy/No Answer.
Setting, canceling or Call Forwarding is allowed only while logged
¥
out of ACD.
General:
When a station with Call Forward assigned receives a second call,
¥
and Call Forward is set to a busy station, the second incoming call
does not follow the forwarding assignment until the forwarding station
goes idle.
All internal and transferred calls to the station follow the Call
¥
Forward - Busy/No Answer setting.
Tie/DID and DIT/ANA line calls follow the Call Forward - Busy/No
¥
Answer settings.
A station can be the destination of any number of Call
¥
Forward - Busy/No Answer settings.
Call Forward - All Call has higher priority than Call Forward - Busy/
¥
No Answer.
When Call Forward - Busy/No Answer is set, camped-on calls and
¥
DIT/ANA calls forward after the No Answer Time expires.
Extensions cannot
Issue 6
be set for Call
C - 35