NEC Electra Elite 48/192 Features And Specifications Manual page 311

Issue 6
E - 8
Use Memory Block 1-1-53 (Tie Line Delay Ring Pattern Selection) to
¥
select the delay ring Pattern (default: Pattern D).
Use Memory Block 1-1-69 (Tie Line Code Restriction Assignment) to
¥
assign YS (outgoing Tie Line dialed digits are code Restricted) or NO
(no restriction). Default is YS. With code restriction assigned, an
access code must be entered in front of the dialed number in the
8-digit matching tables to dial out of a distant system.
Use Memory Block 3-27 (Tie Line Dial Tone Selection) to send
¥
(default: YS) or disable (NO) Dial tone on E&M Tie Lines to distant
systems.
Use Memory Block 3-29 (Trunk Internal Transmit Pad Selection) to
¥
specify (Default: 8 dB) Internal Transmit pad adjustment (volume
level).
Use Memory Block 3-30 (Trunk Internal Receive Pad Selection) to
¥
specify (Default: 8 dB) Internal Receive pad adjustment (volume
level).
Use Memory Block 3-31 (Trunk External Transmit Pad Selection) to
¥
specify (Default: 0 dB) External Transmit pad adjustment (volume
level).
Use Memory Block 3-32 (Trunk External Receive Pad Selection) to
¥
specify (Default: 0 dB) External Receive pad adjustments (volume
levels) can be specified.
Use Memory Block 3-92 [Trunk (Installed, DP/DTMF) Selection] to
¥
specify each line of the TLI(2)-U10 ETU as MF (default), DP 10pps,
DP 20pps signaling, or NIL (not connected) on E&M Tie Lines.
Use Memory Block 4-01[CO/PBX Ring Assignment (Day Mode) or
¥
4-02 [CO/PBX Ring Assignment (Night Mode)] to set an unanswered
Tie/DID call to ring using Day or Night Mode ringing assignment.
Use Memory Block 4-32 (Trunk Digit Restriction) to restrict each
¥
station in the system to a maximum number of digits or no limit
(default: 00, no limit) that can be dialed out on a Tie line when Code
Restriction is assigned.
Use Memory Block 5-00 (Digit Add/Del for Tie Line Networking
¥
Assignment) to assign Tie/DID lines to add up to two digits or delete
up to two digits per Trunk group as needed. Default is not assigned.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
¥
the TLI(2)-U10 ETU.
Electra Elite
E&M Tie Lines (4-Wire)