Issue 6
SYSTEM AVAILABILITY
OPERATING
PROCEDURES
SERVICE
CONDITIONS
V - 10
Terminal Type:
All Multiline Terminals
Required Components:
IPT(4)/(8)-U10 ETU
Use any combination of manual dialing, Save and Repeat, Save
and Store, Last Number Redial, Station Speed Dial, and System
Speed Dial.
Data Assignment:
¥
The IPT(4)/(8)-U10 ETU can communicate only with another
IPT(4)/(8)-U10 ETU that may reside on a remote KTS.
General:
¥
Memory Block 1-1-59, (Synchronous Ringing Selection), must be set
to NO when the IPT(4)/(8)-U10 ETU is used as a COI/COIB/COID
ETU.
¥
The LIVE LED flashes when the ETU is receiving power from the
KSU.
¥
Two LEDs on the RJ-45 Connector indicate the Ethernet status. A
yellow LED indicates the Ethernet Link is up, and a blinking green
LED indicates activity.
¥
Eight STATUS LEDs are provided to indicate the status of an
associated trunk or channel when COID or DID mode is selected.
Indications are as follows:
Trunk Status
Not installed
Idle
Incoming
Busy
LED for COID
LED for DID
Off
Off
Off
On
Voice Over Internet Protocol (VoIP)
Electra Elite
Off
Off
On
On