NEC Electra Elite 48/192 Features And Specifications Manual page 519

Issue 6
SERVICE
CONDITIONS
S - 14
To answer outside or internal calls:
Lift the handset, and communicate.
To transfer an outside call or internal call with a call in progress:
1. Press the hookswitch momentarily, and wait for internal dial tone.
2. Dial the station number where call is to be transferred.
3. Hang up.
To access feature:
1. Lift the handset, and wait for internal dial tone.
2. Dial the Feature Access Code.
Data Assignment:
All Feature Access Codes can be used from a Single Line Telephone
¥
when allowed by Station Class of Service and applicable
assignments.
Use Memory Block 1-3-01 (Bounce Protect Time Selection) to specify
¥
the time (default: 300 ms) before a valid hookflash is detected from
an SLT.
Use Memory Block 1-3-02 (SLT Hookflash Signal Selection) to
¥
specify Whether a line is held internally (default: HOLD) or a
hookflash (FLASH) is sent to an outside line when a Single Line
Telephone user performs a hookswitch.
Use Memory Block 1-3-03 (First Digit PBR Release Time Selection)
¥
to specify the time (default: 10 seconds) that a PBR circuit is
connected before disconnecting when a DTMF SLT user goes off-
hook. When user dials a digit before the PBR is disconnected, PBR
interdigit time begins.
Use Memory Block 1-3-04 [Dial 1 (DP) Hookflash Selection] to
¥
specify whether (default: YS) or not (NO) pressing 1 during an
intercom call or a CO/PBX call on a DP Single Line Telephone
provides a hookflash signal (default is YS).
Electra Elite
Single Line Telephone Access