NEC Electra Elite 48/192 Features And Specifications Manual page 166

Electra Elite
Features and Specifications Manual
General:
Features like Code restriction, or forced account codes that are
¥
enabled for the Call Forward – Off-Premise extension apply to any
call that follows Call forward – Off-Premise.
The Feature key LED flashes red when Call Forward – Off-Premise
¥
(All Calls) is set from a Multiline Terminal.
The ACD/UCD overflow destination station can be set to Call
¥
Forward – Off-Premise.
The Access Codes for Call Forward set and cancel can be
¥
programmed on Feature Access keys or One-Touch keys. Press the
key during the conversation with an internal or outside party to place
the call on hold and dial the Access Code.
When a Call Forward ON/OFF key (All Call or Busy/No Answer) is
¥
programmed on the line key, set/cancel toggles. The Trunk Access
Code and destination outside number must be dialed after pressing
this key when setting Call Forward – Off-Premise.
Incoming calls from a voice mail system follow the Call
¥
Forward – Off-Premise setting.
The Call Arrival (CAR) key number can be set for Call
¥
Forward – Off-Premise.
required.
The Speed Dial number cannot be set as the destination forward
¥
number.
When the system is installed in the Key Function (KF) mode, a
¥
Specified Line Seizure Access Code must be used when setting Call
Forward – Off-Premise.
The following incoming calls can be forwarded:
¥
• CO/PBX Transfer Call
• Ordinary Incoming Internal Call
• Direct Inward Termination (DIT)
• Assigned Night Answer (ANA)
• Direct Inward Dialing (DID)
• Tie Line (TIE)
• Automated Attendant (AA)
When the outside party, where the call is forwarded, is busy or does
¥
not answer, the call is terminated when the calling party hangs up.
System Software S4000 or higher is
Issue 6
C - 47