Issue 6
E - 26
Use Memory Block 1-1-24 (PBX/CTX Access Code Assignment 1)
¥
and Memory Block 1-1-25 (PBX/CTX Access Code Assistant 2) to
assign access codes when CTX/PBX trunks are assigned.
¥
Use Memory Block 3-33 (Disconnect Recognition Time Selection) to
assign the time the dropped line remains idle before the line is seized
for 911 calls.
Restrictions
¥
The station user cannot press a busy Direct CO Line and dial
9+911or 911.
¥
When 911 is not dialed continuously (e.g. dial 9+1+RECALL+1), the
911 call is not placed.
When Memory Block 3-92 is assigned as NIL and Memory Block 3-
¥
69, is set to YES, Emergency 911 - Cut Through feature is not
supported.
When all trunks in Memory Block 3-69 are set to No, the Emergency
¥
911 - Cut Through feature is not supported.
CAMA trunk and Emergency 911 - Cut Through cannot be used at
¥
the same time.
¥
When the CO line status is as follows, even when Yes is specified by
Memory Block 3-69, the call is not dropped and/or disconnected.
•
Receiving Normal Incoming call
•
Receiving DIT call
•
Incoming Automated Attendant
•
Originating 911 call
•
Receiving ACD Incoming call
¥
Emergency 911 - Cut Through does not override the following
features:
•
Digit Restriction set in Memory Block 4-19 (Trunk Outgoing
Restriction)
•
Automatic Trunk-to-Trunk Transfer (out going trunk only)
•
Attendant Station Outgoing Lockout
•
FAX branch Connection
When a station dials 911 while a line is being used by the Fax Branch
¥
Connection, this line is not dropped.
Electra Elite
Emergency 911 - Cut Through