NEC Electra Elite 48/192 Features And Specifications Manual page 28

Electra Elite
Features and Specifications Manual
Use Memory Block 1-8-08 [Class of Service (Station) Feature
¥
Selection 2], Page 6 LK3 to Allow (LED On) or Deny (default: LED
Off) Account Code Forced/Unverified. System software S5000 or
higher is required.
Use Memory Blocks 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
¥
Assignment] to assign the Forced Account Code Access (Function
No. 147).
Use Memory
¥
Assignment) to assign the number of digits for Account Codes
system-wide. One to 13 digits can be assigned; default is 10 digits.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
¥
the necessary MIFM-10 ETU.
Restrictions:
Existing restrictions and Least Cost Routing (LCR) assignments are
¥
applied after Forced Account Codes are entered.
When a 911 call is placed, Account Code Forced/Verified is
¥
overridden by the following:
• Emergency 911 Cut-Through is enabled.
• A CAMA trunk is installed and enabled.
Enhanced 911 calls override the forced account code and are
¥
controlled by the Emergency 911 Dialing Route Assignment.
Verified and Unverified Forced Account Codes cannot be used in the
¥
same Class of Service.
General:
System Software S5500 or higher is required for Scrolling
¥
Directories to be used with this feature.
Only outgoing calls from an intercom require a Forced Account
¥
Access Code. Direct access to trunks bypasses this feature.
Reorder tone is provided when an outgoing call is dialed without
¥
entering the Forced Account Access Code and a Forced Account
Code.
Call Alert Notification is not provided during Account Code Entry
¥
verification and programming.
PBR Time values apply when a Single Line Telephone is used to
¥
enter a Forced Account Code.
Forced Account Codes can be uploaded, downloaded, or modified
¥
using PC based System Programming.
Block 1-8-27 (Forced
Issue 6
Account Code Length
A - 7