NEC Electra Elite 48/192 Features And Specifications Manual page 75

Issue 6
RELATED FEATURES
LIST
A - 54
Use Memory Block 3-38 (Automated Attendant Message to Trunk
¥
Selection) to assign the Automated Attendant message per CO/PBX
trunk.
Use Memory Block 7-1 (Card interface Slot Assignment) to specify
¥
the VRS(4)-U10 ETU.
Restrictions:
Tie/DID lines are not supported by the Automatic Answer with Delay
¥
Message feature.
DTMF digits cannot be dialed by the outside caller while in the
¥
Automatic Answer with Delay Message mode.
CPUB( )-U10 ETU/MBD-U10 Unit PBR circuits are not used for this
¥
feature.
Automatic Answer with Delay Message or Automated Attendant is
¥
assigned per trunk.
Automatic Trunk-to-Trunk Transfer and Automated Attendant cannot
¥
be set for the same trunk at the same time.
General:
The Automatic Answer with Delay Message feature uses the
¥
Automated Attendant Message to play to the outside caller.
DIT/ANA assigned to the same trunk has higher priority.
¥
Automated Attendant and system Access Codes can be assigned
¥
individually.
Automated Attendant is assigned to tenants and follows the tenants
¥
Day/Night/Weekend mode switching.
When Automated Attendant answer is assigned for a trunk and a
¥
VRS(4)-U10 ETU is not installed, second dial tone is provided for
incoming callers.
Feature
Number
D-10
Feature Name
Direct Inward System Access (DISA)
Automatic Answer with Delay Message
Electra Elite