NEC Electra Elite 48/192 Features And Specifications Manual page 520

Electra Elite
Features and Specifications Manual
Use Memory Block 1-3-05 (Hookflash Start Time Selection)) to
¥
specify the minimum hookflash duration (default: 290 ms) from the
SLT.
Use Memory Block 1-3-06 (Hookflash End Time Selection) to specify
¥
the maximum hookflash duration (default: 700 ms after hookflash
start time) from the SLT to receive a second dial tone.
Use Memory Block 1-8-01 (SLT or Automated Attendant/DISA to
¥
CPU PBR Selection) to designate the PBR circuits in the CPUB( )-
U10 ETU/MBD-10 Unit to be used for SLTs or for the Automated
Attendant/DISA (no default).
Use Memory Block 4-24 (SLT Hookflash Assignment) to specify
¥
whether an SLT hooking operation holds (default: HOLD) or
disconnects (DISC) a trunk.
Use Memory Block 4-35 (Voice Mail/SLT Selection) to specify
¥
whether (YS) or not (default: NO) a Voice Mail system is interfaced
with the system for SLT ports.
Use Memory Block 4-95 (DTMF/DP SLT Type Selection) to specify
¥
whether Dial Pulse (DP) or DTMF (default: MF) SLT is connected to
the system per port.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
¥
the SLI(4)/(8)-U10 ETU or OPX(2)-U10 ETU.
System Software S4000 or higher.
When a rotary type 500 Single Line Telephone is used, Access
¥
Codes using # and
this telephone does not support these digits.
Restrictions:
The SLT(1)-U10 ADP and OPX(2)-U10 ETU do not support Message
¥
Waiting.
The APA-U Unit does not support ringing.
¥
General:
Single Line Telephones provide a distinctive ringing pattern between
¥
CO/PBX incoming calls and internal calls.
Both DTMF type 2500 and Rotary type 500 Single Line Telephones
¥
can be used with the system.
Message Wait LEDs light when a message is sent to a Single Line
¥
Telephone with Message Wait LED.
A Single Line Telephone can be used to voice announce to a
¥
Multiline Terminal.
must be changed to numerical digits because
,
Issue 6
SLI(4) requires
S - 15