NEC Electra Elite 48/192 Features And Specifications Manual page 288

Electra Elite
Features and Specifications Manual
.
To Use the Charging Unit:
1. Place handset and/or spare battery in the charging slots.
2. The Charge 1 LED is on red during and after charging the
handset.
3. The Charge 2 LED is on red while charging the spare battery and
turns after charging is complete.
Note:If the handset is placed in the charger without an installed battery, the
Charge 1 LED flashes.
.
To Switch from Cordless to Desk Using Base Unit:
1. When Cordless II is associated with a terminal, use the base unit
to switch between Cordless II and the Multiline Terminal.
Figure D-1 Cordless II Base Unit Controls.
2. Either press Cordless to select D
3. Or Press Desk to select Multiline Terminal.
Note:Switching must be accomplished while both terminals are idle.
Note:A call in progress cannot be switched. When tried, it is dropped.
Note:Switching held calls is not recommended because LED indications
are not provided.
Note:The Power LED and the applicable position LED are on to indicate
selection.
Figure D-1 Cordless II Base Unit Controls
To Switch from Desk to Cordless using Redial Key:
term
Cordless II.
Issue 6
Refer to
D - 79