NEC Electra Elite 48/192 Features And Specifications Manual page 402

Electa Elite
Features and Specifications Manual
Data Assignment for CO Line Services:
Use Memory Block 3-52 (ISDN Trunk Directory Number Assignment)
¥
to assign the ISDN Directory Number.
Use Memory Block 3-91 (Trunk Type Selection) to specify each
¥
ISDN-PRI trunk as CO Lines.
Use Memory Block 4-12 (Line Key Selection for Telephone Mode) to
¥
assign the Trunk Appearance, Route Advance Block or CAP key to
term
line keys for D
Use Memory Block 4-01 [CO/PBX Ringing Assignment (Day Mode)]
¥
to assign ISDN-PRI trunks to ring during day mode at specified
stations.
Use Memory Block 4-02 [CO/PBX Ringing Assignment (Night Mode)]
¥
to assign ISDN-PRI trunks to ring during night mode at specified
stations.
Use Memory Block 1-1-81 (ISDN Dial Interval Time Selection) to
¥
specify the time (default: 4s) between dialed digits.
Data Assignment for DID Line Services:
Use Memory Block 3-91 (Trunk Type Selection) to specify each
¥
ISDN-PRI trunk as DID Lines.
Note:Refer to D-9 Direct Inward Dialing in the Features and Specifications
Manual to convert incoming digits to the correct Station number.
Data Assignment for Call by Call:
Use Memory Block 1-13-03 (Call by Call Service Selection) to
¥
specify whether YS or NO (default) Call by Call service is activated
per PRT.
Use Memory Block 1-10-00 (Call by Call Type of Network ID
¥
Assignment) to assign the Network ID.
Use Memory Block 1-10-01 (Call by Call ID Plan Assignment) to
¥
assign the Numbering Plan Identifier (default: 1).
Use Memory Block 1-10-02 (Call by Call Type of Number
¥
Assignment) to assign the type of number (default: 0).
Use Memory Block 1-10-03 (Call by Call Numbering Plan ID
¥
Assignment) to assign the Numbering Plan ID (default: 00).
Use Memory Block 1-10-04 (Call by Call Network ID Assignment) to
¥
assign the Network ID (default: Not Specified).
Station using ISDN-PRI.
Issue 6
I - 19