NEC Electra Elite 48/192 Features And Specifications Manual page 280

Electra Elite
SERVICE
CONDITIONS
Features and Specifications Manual
When the 2-digit number is entered incorrectly, an error tone is heard
when chan is pressed. The LCD clears but the lock icon remains on as
the telephone goes into standby mode.
General:
¥ Only one cordless terminal can be connected per ESI port.
¥ Either cordless terminal can be used as a stand-alone device.
Any cordless terminal can interface to every ESI port available in the
¥
term
system. For D
term
all D Cordless Terminals in the system. For D
up to 30 channels can be shared.
term
¥ The D Cordless Terminal operating frequency ranges from
902.75 MHz to 925.70 MHz and the D
from 902 MHz to 928 MHz. Both terminals share this frequency
range with other devices. Interference or channel blockage could
occur from these other devices.
¥ Both terminal LCDs display DISCONNECT indicating the cordless
terminal is disconnected or the system is out of power.
term
The D Cordless Terminal LCD displays ICM HOLD when an
¥
internal call is placed on hold. With the D
the Hold key causes the associated function key to flash.
When there is no transmission between the base unit and the
¥
handset for about five minutes, there are no LCD or LED indications
on the cordless terminal handset. Ringing off-hook or pressing keys
resumes LCD and LED indications.
¥ A green LED is not provided with the cordless terminals. The LED
data for the green LED lights an LED on the cordless terminal.
Paging the other cordless terminal using the internal paging feature is
¥
not recommended. The cordless terminal cannot answer an internal
page with Meet-Me when it is paged using internal paging.
-OR-
Cordless nine voice channels must be shared by
term
Cordless Lite,
term
Cordless Lite operates
term
Cordless Lite, pressing
Issue 6
D - 71