NEC Electra Elite 48/192 Features And Specifications Manual page 193

Issue 6
C - 74
Use Memory Block 1-1-24 (PBX/CTX Access Code Assignment I)/
¥
1-1-25 (PBX/CTX Access Code Assignment II) to specify the PBX/
Centrex Trunk Access Codes When the system is installed behind a
PBX or Centrex. This code is ignored when dialed.
¥ Use Memory Block 1-1-62 (System Speed Dial Override by Class
Selection) to assign Classes 01~14, per Class, to YS (override
System Speed Dial).
¥ Use Memory Block 1-1-69 (Tie Line Code Restriction Assignment) to
assign Code Restriction for Tie line use system-wide (default: YS).
¥ Use Memory Block 1-1-70 (Code Restriction Class Assignment when
Lockout is Set) to assign a preprogrammed Code Restriction class
when Attendant Station Outgoing Lockout or Station Outgoing
Lockout is set (default: Class 15, Outgoing Restricted).
Code Restriction is allowed or denied per Trunk group.
¥
General:
¥ At default, the 14 programmable station classes are assigned as
follows:
Class 01:
Class 02:
Class 03:
Class 04:
Class 05~14:

All classes deny OCC calls.

Classes 01~04 allow local calls.
¥ The use of other common carriers (equal access) can be allowed or
denied by the Code Restriction feature.
¥ Code Restriction applies after CO Feature Code is dialed.
When using Code Restriction with LCR, Code Restriction is applied
¥
to the digits dialed by the system.
Deny 0 and 1+ calls
Deny 0 and 1+ calls, Allow 1-800, 1-888, 1-877 calls
Deny 0, 1+, and 976 calls, Allow 1-800, 1-888, 1-877
calls
Deny only 1+ calls, Allow 1-800, 1-888, and 1-877
calls
Allow only 911 calls
Electra Elite
Code Restriction