NEC Electra Elite 48/192 Features And Specifications Manual page 341

Issue 6
SERVICE
CONDITIONS
E - 38
To originate using a Single Line Telephones:
1. Lift the handset.
2. Dial the desired Access Code
default) for the required zone.
To answer using a Single Line Telephones:
1. Lift the handset.
2. Dial the Meet-Me Access Code (
Internal/External Page, or
External Page, as set in default).
Data Assignment:
Use Memory Block 1-7-06 (External Paging Timeout Selection) to
¥
specify the External timeout time (default: 5 minutes) before a page
automatically disconnects.
Use Memory Block 1-7-03 (External Paging Alert Tone Selection) to
¥
specify whether (YS/NO) an alert tone is sent to external speakers at
the beginning of the external page.
Use Memory Block 1-7-02 (External Speaker Connection Selection)
¥
to specify that external speakers must be connected to the system
when they are to be used. Up to three external speakers can be
connected. Default is all three connected.
¥ Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
the ECR-U10 ETU.
Internal and External Zone Paging time outs can be assigned
¥
individually. During an All Internal/External Zone Page, the external
timeout time is used.
Restrictions:
When an External Zone Page is in progress (either Zone A, B, C, or
¥
All Zone), no other station can activate External Zone Paging until all
zones become idle again.
¥ A single paging zone that provides pre-alert tone only is built in on
the Electra Elite 48 system. Chime tone is not supported.
E E E I
~
E J
, when the page is an
E L
, when the page is only an
External Zone Paging (Meet-Me)
Electra Elite
( as set in