Siemens SINAMICS G150 Manual page 595

10
15
Note: The individual bits are only set if the appropriate action has been initiated and successfully completed.
When motor rating plate parameters are changed, the final display is reset.
r3927[0...n] Motor data identification control word / MotID STW
VECTOR_G Can be changed: -
Data type: Unsigned32
P-Group: Motor identification
Not for motor type: -
Min
-
Description: Successfully completed component of the last motor data identification carried out.
Bit field: Bit
00
01
02
03
04
05
06
07
11
12
14
15
16
17
18
19
20
21
Dependency: Refer to: r3925
Note: The parameter is a copy of p1909.
r3928[0...n] Rotating measurement configuration / Rot meas config
VECTOR_G (n/M) Can be changed: -
Data type: Unsigned16
P-Group: Motor identification
Not for motor type: REL
Min
-
Description: Successfully completed component of the last rotating measurement carried out.
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
Automatic parameterization only for U/f
control (r0108.2 = 0)
Motor equivalent circuit diagram parameters
changed
Signal name
Stator inductance estimate no
measurement
Cl.-loop current control w/ dead-beat
controller
Rotor time constant estimate no
measurement
Leakage inductance estimate no
measurement
Activates the identification dynamic leakage
inductance
Determine Tr and Lsig evaluation in the time
range
Activate vibration damping
De-activate vibration detection
De-activate pulse measurement Lq Ld
De-activate rotor resistance Rr
measurement
De-activate valve interlocking time
measurement
Determine only stator resistance, valve
voltage fault, dead time
Short motor identification (lower quality)
Measurement without control parameter
calculation
After motID direct transition into operation
After MotID automatically save results
Estimate cable resistance
Calibrating the output voltage measurement Yes
Yes
Yes
Calculated: CALC_MOD_ALL
Dyn. index: DDS, p0180
Units group: -
Scaling: -
Max
-
1 signal
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Calculated: CALC_MOD_ALL
Dyn. index: DDS, p0180
Units group: -
Scaling: -
Max
-
2 Parameters
2.2 List of parameters
No
No
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
0 signal
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
-
-
FP
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
595