Siemens SINAMICS S120 Function Manual page 65

● Non-volatile storage of the setpoints via p1030.3 = 1
● Configurable setpoint for Power ON (p1030.0)
– Starting value is the value in p1040 (p1030.0 = 0)
– Starting value is the stored value (p1030.0 = 1)
Function diagrams (see SINAMICS S120/S150 List Manual)
● 3001
● 2501
● 3020
Overview of important parameters (see SINAMICS S120/S150 List Manual)
● p1030[0...n]
● p1035[0...n]
● p1036[0...n]
● p1037[0...n]
● p1038[0...n]
● p1039[0...n]
● p1040[0...n]
● p1041[0...n]
● p1042[0...n]
● p1043[0...n]
● p1044[0...n]
● r1045
● p1047[0...n]
● p1048[0...n]
● r1050
● p1082[0...n]
Drive functions
Function Manual, 06/2019, 6SL3097-5AB00-0BP2
Setpoint channel overview
Internal control/status words - Control word, sequence control
Setpoint channel - Motorized potentiometer
Motorized potentiometer configuration
BI: Motorized potentiometer, setpoint, raise
BI: Motorized potentiometer, setpoint, lower
Motorized potentiometer, maximum speed
Motorized potentiometer, minimum speed
BI: Motorized potentiometer, inversion
Motorized potentiometer start value
BI: Motorized potentiometer, manual/automatic
CI: Motorized potentiometer, automatic setpoint
BI: Motorized potentiometer, accept setting value
CI: Motorized potentiometer, setting value
CO: Motorized potentiometer, speed setpoint in front of the ramp-
function generator
Motorized potentiometer, ramp-up time
Motorized potentiometer, ramp-down time
CO: Motorized potentiometer, setpoint after the ramp-function gener‐
ator
Maximum speed
Extended setpoint channel
4.1 Motorized potentiometer
63