Using Functions That Require A License - Siemens SINAMICS S120 Function Manual

Web server
13.6 System settings
3. If you want to switch to a secured connection, activate the "Only permit secure access using
HTTPS protocol" option.
Figure 13-27
Note
Switchover from HTTP to HTTPS
If you were logged-in via HTTP, you will be logged-out after activating the option "Only
permit secure access using HTTPS protocol". To log in again, you must set a secure HTTPS
connection (https://...) to the converter.
Note
Certificates for the secure data transfer
To secure an HTTPS connection, it requires security certificates for the encryption of the
access. Detailed information on working with these security certificates can be found in
Chapter "Certificates for the secure data transfer (Page 731)".
4. Click "Apply Settings" to save the changes in the RAM of the device.
5. Click
You have configured the IP connection.
13.6.4

Using functions that require a license

To display the license status, click on "Licenses" in the "System" navigation.
Using this page, also enter a license key that you purchased through the Web License
Manager.
If you still do not have a license - however, you wish to set up and test functions that require a
license, then you have the option of activating the Trial License Mode. Details are provided in
the following chapter.
760
IP connections
to save the data permanently.
Function Manual, 06/2019, 6SL3097-5AB00-0BP2
Drive functions