Protective Equipment; Overview Of The Important Parameters - Siemens SINAMICS S120 Function Manual

Basic functions
8.14 Motor Module as a Braking Module
8.14.3

Protective equipment

Function description
The protection functions are explained in detail in Section Thermal monitoring and overload
responses (Page 595). Additional protective devices include:
● Ground fault
Monitoring of sum of all phase currents.
● Cable break
An unbalanced load of 20 % and more produces a non-symmetrical current, which is
detected by the I
– Alarm A06921 is output if phase non-symmetry is detected.
– The errors are located in parameter r0949:
– Fault F06922 is output if phase failure is detected.
● Overcurrent
The Imax controller is active. The setpoint is stored in parameter p0067.
● Overtemperature of the resistors
The temperature is monitored using bimetal temperature switches mounted on the resistors.
Configuring temperature evaluation contacts
To configure the temperature evaluation contacts, perform the following steps:
1. Switch the temperature evaluation contacts of all 3 resistors in series.
2. Connect the temperature evaluation contacts to the temperature sensor evaluation of the
Motor Module (terminals X41.3 and X41.4).
3. For the temperature monitoring, set the temperature sensor via Motor Module (p0600 = 11).
4. Set sensor type "Bimetallic NC contact warning & timer" as motor temperature sensor
(p0601 = 4).
5. Parameterize the temperature sensor evaluation of the Motor Module as "external fault".
8.14.4

Overview of the important parameters

Overview of important parameters (see SINAMICS S120/S150 List Manual)
● r0207[0...4]
● r0949[0...63]
● p1300[0...n]
● p1330[0...n]
● p1360
352
T monitoring.
2
Parameter r0949 = 11 Wire break phase U
Parameter r0949 = 12 Wire break phase V
Parameter r0949 = 13 Wire break phase W
Rated power unit current
Fault value
Open-loop/closed-loop control operating mode
CI: V/f control independent of voltage setpoint
Braking Module braking resistor, cold
Function Manual, 06/2019, 6SL3097-5AB00-0BP2
Drive functions