Function Diagrams And Parameters - Siemens SINAMICS S120 Function Manual

You can configure the band-stop filters for the Active Infeed using the following parameters:
● Negative phase-sequence system control (p3639 ff)
● Fixed setpoints (p2900 ff)
● Output voltage setpoint filter; activation with p5200.0 = 1
● Actual current value filter; activation with p5200.2 = 1
● Vdc actual value filter; activation with p1656.4 = 1
3.1.8

Function diagrams and parameters

Function diagrams (see SINAMICS S120/S150 List Manual)
● 8910
● 8920
...
● 8940
● 8946
...
● 8964
Overview of important parameters (see SINAMICS S120/S150 List Manual)
● r0002
● r0046.0...29
● r0069[0...8]
● p0210[0...1]
● p0220[0...1]
● p0255[0...7]
● p0280
● p0840
● p0844
● p0852
● r0898.0...10
● r0899.0...12
● r2138.7...15
● r2139.0...15
● p3400
● r3405.0...7
● p3410
Drive functions
Function Manual, 06/2019, 6SL3097-5AB00-0BP2
Active Infeed overview
Active Infeed - Control word, sequence control, infeed
Active Infeed - controller modulation depth reserve / controller DC link voltage
(p3400.0 = 0)
Active Infeed - current precontrol / current controller / gating unit (p3400.0 = 0)
Active Infeed - signals and monitoring function, line frequency/Vdc monit.
(p3400.0 = 0)
Infeed operating display
CO/BO: Missing enable signals
CO: Phase current actual value
Device supply voltage
Infeed line filter type
Power unit contactor monitoring time
DC link voltage maximum steady-state
BI: ON/OFF (OFF1)
BI: No coast down / coast down (OFF2)
BI: "Enable operation/Inhibit operation"
CO/BO: Control word sequence control infeed
CO/BO: Status word sequence control infeed
CO/BO: Control word, faults/alarms
CO/BO: Status word, faults/alarms 1
Infeed configuration word
CO/BO: Infeed status word
Infeed identification method
Infeed
3.1 Active Infeed
41