Installation Of Dispensepac Support - ABB IRC5 Product Manual

2 Installation and commissioning

2.9.10 Installation of DispensePac support

2.9.10 Installation of DispensePac support
About DispensePac
To use the DispensePac option you need to connect externally placed Process I/O
board(s). The procedure below shows how to connect the DeviceNet cable from
the Process I/O board to the DeviceNet signal cable from the Process Interface
Board.
Location
The illustration below shows the location of the Process Interface Board and the
connection point of the DeviceNet cable(s).
xx0900000130
A
B
Connecting Process I/O boards
1
2
164
Process Interface Board
A57.X1 and A57.X2 DeviceNet connectors
Action
The DeviceNet cable from the Process I/O board
(not included in the DispensePac support option)
is connected (without termination resistance) to the
DeviceNet cable, marked A57.XT1/XT2, from the
Process Interface Board.
If a second Process I/O board is to be connected,
remove the termination resistance on the second
cable and connect the second Process I/O board
to this cable.
© Copyright 2004-2018 ABB. All rights reserved.
B
Note
The connectors A57.XT1 and
A57.XT2 are found on the bottom
of the Controller cabinet, at the
end of the cable from the Process
Interface Board.
Product manual - IRC5
3HAC047136-001 Revision: M
A