ABB IRC5 Product Manual page 136

2 Installation and commissioning
2.9.6 Installation of the option Hot plug
Continued
Procedure Single Cabinet Controller
The procedure below details how to install the hot plug button in the controller.
1
2
3
4
5
Continues on next page
136
Action
DANGER
Before commencing any work inside the
cabinet, please observe the safety inform-
ation in section Make sure that the main
power has been switched off on page
WARNING
The unit is sensitive to ESD. Before hand-
ling the unit please read the safety inform-
ation in the section The unit is sensitive to
ESD on page 34
Disconnect the cable from the ethernet
connector for FlexPendant on the computer
unit.
Disconnect signal cabling from the panel
board unit.
Remove the FlexPendant connector with
harness from the Operator panel.
© Copyright 2004-2018 ABB. All rights reserved.
Note/Illustration
26.
xx0600002946
• A: Connector X10
xx0600002948
• A: FlexPendant connector
Product manual - IRC5
3HAC047136-001 Revision: M