ABB IRC5 Product Manual page 294

4 Repair
4.26.3 Replacement of system power supply
Continued
Removal
The procedure below details how to remove the system power supply.
1
2
3
4
5
Refitting
The procedure below details how to refit the system power supply.
1
Continues on next page
294
Action
DANGER
Before commencing any work inside the cabinet,
please observe the safety information in section
Make sure that the main power has been switched
off on page 26.
Disconnect all connectors from the unit.
Loosen the two lower attachment screws.
Remove the two upper attachment screws.
Pull the power supply unit outwards and then up-
wards to release it from the lower screw heads, and
remove it.
Action
DANGER
Before commencing any work inside the cabinet,
please observe the safety information in section
Make sure that the main power has been switched
off on page 26.
© Copyright 2004-2018 ABB. All rights reserved.
Note/Illustration
xx0700000125
• A: upper attachment
screws
• B: lower attachment screws
Note/Illustration
Product manual - IRC5
3HAC047136-001 Revision: M