Connecting A Flexpendant - ABB IRC5 Product Manual

2 Installation and commissioning

2.5.7 Connecting a FlexPendant

2.5.7 Connecting a FlexPendant
Location of FlexPendant connector
The FlexPendant connector on the IRC5 controller is located on the operator's
panel on the controller, or on an external operator's panel.
xx0600002782
L
Connecting a FlexPendant
1
2
3
76
CAUTION
Always inspect the connector for dirt or damage before connecting it to the
controller. Clean or replace any damaged parts.
FlexPendant connector (A22.X1)
Action
Locate the FlexPendant socket connector
on the controller or operator's panel.
Plug in the FlexPendant cable connector.
Screw the connector lock ring firmly by
turning it clockwise.
© Copyright 2004-2018 ABB. All rights reserved.
Information
The controller must be in manual mode. If
your system has the option Hot plug, then
you can also disconnect in auto mode. See
section Using the hot plug option on
page 77.
Product manual - IRC5
3HAC047136-001 Revision: M