Replacement Of Expansion Board In The Computer Unit - ABB IRC5 Product Manual

4 Repair

4.9 Replacement of expansion board in the computer unit

4.9 Replacement of expansion board in the computer unit
Location
To connect a serial channel or a fieldbus adapter to the controller, the main
computer must be equipped with the expansion board DSQC1003.
The expansion board is located in the computer unit as shown below.
xx1300000860
A
Required equipment
Equipment
Expansion Board
Standard toolkit
Removal
The following procedure describes how to remove the expansion board from the
computer unit.
1
Continues on next page
232
A
Expansion board with serial channel and one slot for AnybusCC fieldbus adapter.
Action
DANGER
Before commencing any work inside the
cabinet, please observe the safety inform-
ation in section Make sure that the main
power has been switched off on page
© Copyright 2004-2018 ABB. All rights reserved.
Art. no. Note
3HAC046408-001 DSQC1003
The contents are described in
section
page
Note/Illustration
26.
Standard toolkit, IRC5 on
305.
Product manual - IRC5
3HAC047136-001 Revision: M